Matrix Setu ATA211G Especificações descarregar pdf (Página 77)

Matrix SETU ATA211G System Manual 71

Dialed Number Table

Dialed Number Table allows the SETU ATA211G to select the most suitable trunk for outgoing calls on the basis of

the number dialed.

You must configure this table, if you have selected 'Dialed number based routing' for the FXS Port and the Mobile

Port.

The Dialed Number Table is a list of numbers or part numbers (which you must configure), with a preferred

destination port/trunk for each number: FXS, SIP1, SIP2, SIP3, or Mobile. When the user dials a number, SETU

ATA211G checks the Dialed Number Table for a match using the best fit logic. If a match is found, it uses the port/

trunk selected for the number in the table to route the call.

In the Dialed Number table, up to 100 numbers can be stored.

Each number is stored at an Index in the table. For each number that you enter in the table, you must define:

• the minimum number of digits that the system should wait to receive to consider it a valid number to be

dialed out.

• the maximum number of digits which the system should wait to receive to consider it as “End of Dialing”

and dial out the number.

• the Destination Route (SIP Trunk, Mobile port or FXS port), which the system should use to dial out the

number.

The Dialed Number Table is to be configured only if you have selected:

• the Outgoing Call Routing option for the FXS port as Route all calls as per Dialed Number Table.

• the Incoming Call Route for the Mobile port as Dialed Number Table.

When a number is dialed from the FXS port or received on the Mobile port,

• SETU ATA211G will match the dialed number with the entries of the Dialed Number Table.

• If a match is found, it will check the Minimum Digits programmed for this entry to consider it a valid number.

If the length of the number string you dialed matches with the Minimum Digits programmed for this entry,

and “End of Dialing” is detected

, the system will consider it as a valid number. It will not wait to match it

with the Maximum Digits you configured for this entry. The system will dial out the number using the

Destination Route you have selected for this entry in the table.

However, if the number of digits dialed by you are less than the Minimum Digits you configured, you will get

error tone.

• If the dialed number string exceeds the Minimum Digits, but is less than the Maximum Digits, the system

will check the Maximum Digits programmed for this entry.

• If the length of the dialed number string equals the Maximum Digits programmed for this entry, the system

will not wait for further digits to be dialed. It will consider the Maximum Digits defined as End of Dialing, and

will dial out the number using the Destination Route you selected for this entry in the table.

5. You pressed the # key or the Inter Digit Wait Timer has expired. See “End of Dialing”.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 183 184

Sem comentários

Matrix Setu ATA211G Especificações Página 77