Matrix MD920 Especificações

1Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HYT : 01949 862 012 F : 01949 862 0

10Programming the ovenThe oven can be set for semi-automatic cooking, where the oven is programmed to switch off at a specific time, and for automatic

11When the cooking time is completed, the programme symbol will no longer be shown, auto will flash and the timer will beep. To switch off the beep, p

12Care and MaintenanceIMPORTANTBefore any maintenance is started involving electrical parts, the appliance must be disconnected from the power supply.

13IMPORTANT:• Steam cleaners must not be used when cleaning this appliance.• Once care and maintenance is complete, ensure that all parts are correct

14Refit the protective cover.IMPORTANTNever use screwdrivers or other utensils to remove thelight cover. This could damage the enamel of the oven or th

15Cleaning and Maintenance - Removing the Oven DoorThe oven doors can easily be removed as follows:• Open the door to the full extent (fig. 3.1).• Ope

16Mains Electricity ConnectionWarning! This appliance must be earthedTo connect this appliance to a UK standard mains supply, connect the bridging lin

17Fig.5Green/yellowBlueBrownGreen and Yellow = Earth (PE)Blue = NeutralBrown = LivePlease note:•The mains cable must only be replaced by a qualified

18InstallationImportant Failure to allow adequate ventilation to the appliance may result in overheating or damage to adjacent units and could invalid

19fig. 6Dimensions Oven HousingHeight (mm) 890 877Width (mm) 595 560Depth (mm) 540 560 (min)MD920Dimensions Oven HousingHeight (mm) 718 720Width (mm)

2ImportantThis appliance must only be used for the purpose for which it is intended, i.e. domestic cooking. Any other use could be dangerous and may l

20Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HYT : 01949 862 012 F : 01949 862

3Appliance information:Please enter the details on the appliance rating plate below for reference, to assist CDA Customer Care in the event of a fault

4disposal and enables the constituent materials to be recovered to obtain significant savings in energy and resources. As a reminder of the need to dis

5• Do not use abrasive cleaners or powders that will scratch the surface of the enamel.• Do not attempt to repair the internal workings of your ove

6Oven controls and useCooking function knob To set the function, turn the cooking function knob for the required oven clockwise to the required functi

7When grilling, please note:• Always grill with the oven door closed.• Put the grill pan as close to the grill as possible.• Do not grill for more

8Temperature knob• To set the temperature, turn the temperature knob for the required oven clockwise to the required temperature.• | Once the oven

9 When the correct time is shown on the display, the clock will set after approximately five seconds’ delay.Setting the volume of the beep• When th